Features

• Programmable for stand alone operation with Applied

Motion’s easy to use Si Programmer™ Windows software

(software and programming cable included)

• Can be operated in real time from a host PC or PLC using Applied

Motion’s Si Command Language™ (SCL)

• Can be networked with all other Si™ products via Applied

Motion’s SiNet™ Hub

• DC bus voltage 24-80 VDC motor supply (including ripple)

• Software selectable from 0.8–7.0 amps/phase motor current

• Software selectable Step resolutions from 2,000 to 50,800

steps per revolution

• Software selectable idle current reduction 0, 25, 50

or 100

• 8 user programmable inputs

• 3 optically isolated 24 VDC outputs

• Short circuit and over temperature protection

• Communication via RS232

• 560 watts of usable power

• Screw terminal connector blocks for power and motor,

Wago cage clamp connector for I/O. RJ11 for RS232 port

• MOSFET, dual H-bridge, inaudible PWM amplifier

• 3 state, pulse width modulated current control, switching at

20–30 kHz

• Optional operator terminal (MMI) either standard or backlit

• Drives 4, 6 or 8 lead size 11, 14, 17, 23 and 34 step motors

• CE compliant

Description

The 7080i is a programming step motor driver suitable for a wide

range of motion control applications. It includes a sophisticated

controller integrated with a 560-watt microstepping amplifier.

The 7080i includes Applied Motion’s easy to use Si Programmer

™ Windows software for the rapid development of stand

alone motion control programs. The 7080i can also be commanded

in real time from a host PC or PLC, using the Si Command

Language™.

For multi-axis applications, up to eight Applied Motion Si™

drives (stepper or Servo) can be networked using a single

SiNet™ Hub.

The 7080i includes 8 programmable inputs for triggering,

branching, position sensing and end of travel detection. 3 optically

isolated programmable outputs can send signals to other

electronic devices and activate relays.

The 7080i is a PC board mounted on an aluminum angle heat

transfer chassis. Drive dimensions are 2˝ by 3˝ by 6˝.